QSee QSNDVR9M Manual de usuario descargar pdf (Pagina 13)



: This button is for the IRIS adjustment. If the light in the area where camera is

located is too strong, press

to decrease volume of light, if the light in the area where camera

is located is too weak, press

to increase amount of light.



: Press this button to set the PTZ (Fig1.1.4 PTZF setting)

Internal: If the PC is connected to the DVR in the same local area network, you have to choose Internal

and you do not need to reset the configuration.

External: If the PC is connected to the DVR through the Internet, you have to choose External and setup

the PTZ Controller and Address of each channel.

Channel: Choose the channel which is connected with speed dome camera.

PTZ Controller: Choose the PTZ protocol, which is the same as the protocol set in Fast speed dome and

DVR. The protocol set in the PTZ PROTOCOL, which is in the submenu of the LIVE menu in the DVR.

Address: Choose the PTZ address, which is the same as the address set in Fast speed dome and DVR.

The address set in the PTZ ID, which is the submenu of the LIVE menu in the DVR.

Take the channel 1 as example:

If the PTZ protocol set in the DVR is PELCO_D-2400, it means that the protocol is PELCO_D and the

baud rate is 2400kbps. If the PTZ ID set in the DVR is 01.Press the “Add” button to save the configuration,

the PTZ setting is as fig1.1.4 PTZ setting:

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Sin comentarios

QSee QSNDVR9M Manual de usuario Pagina 13